Instructions
Soak lenses for 8 hours
Guide to Properly Handling and Cleaning Circle Lenses
Step 1: Wash Your Hands Thoroughly
- Use warm water and an unscented antibacterial soap to clean your hands.
- Dry your hands with a lint-free towel or tissue to avoid contamination.
Step 2: Prepare the Lens Case
- Rinse the lens case with a multipurpose contact lens solution (never use tap water).
- Fill each compartment ¾ full with fresh solution to keep the lenses hydrated and free from bacteria.
Step 3: Remove Lenses from the Blister Pack
- Carefully open the blister pack without spilling the solution.
- Use clean, dry fingers or a lens applicator to remove the lens.
- Avoid using fingernails to prevent damage or contamination.
Step 4: Clean the Lenses
- Place the lens on the palm of your hand.
- Apply a few drops of multipurpose solution on the lens.
- Gently rub the lens with your index finger for 10–15 seconds to remove any dirt, germs, or protein buildup.
Step 5: Store & Soak the Lenses
- Place the cleaned lenses into the prepared lens case.
- Ensure they are fully submerged in fresh multipurpose solution.
- Let them soak for at least 8 hours before wearing to ensure proper hydration and disinfection.
Additional Tips for Safe Lens Use
✅ Always use fresh solution—never reuse old solution.
✅ Replace your lens case every 1–3 months to prevent bacterial buildup.
✅ Avoid touching lenses with dirty or wet hands.
✅ Never store or rinse lenses with tap water or saliva (risk of infection).
✅ Follow the recommended wearing schedule to avoid eye irritation.
✅ If you experience redness, irritation, or discomfort, remove the lenses immediately and consult an eye care professional.
How to Insert Contact Lenses
- Wash and Dry Your Hands – Use soap and a clean towel to ensure your hands are completely clean and dry.
- Rinse the Lens – Use contact lens solution to remove any dirt or debris.
- Check the Lens Orientation – Place the lens on the tip of your index finger and check if it’s inside out. If your lenses have a marker, ensure it’s facing the right way.
- Hold Your Eyelid – Use your free hand to gently hold your upper eyelid to prevent blinking.
- Lower Your Eyelid – With the other hand, use your free fingers to pull down your lower eyelid.
- Insert the Lens – Look up and gently place the lens on the lower part of your eye.
- Let Your Eye Adjust – Slowly release your eyelid and close your eye for a moment.
- Blink Naturally – Blink a few times to help the lens settle into place.
- Check for Comfort – If the lens feels uncomfortable, remove it and inspect for debris or damage. If damaged, discard it. Otherwise, rinse with solution and try again.